Description
RotorFlight F722V2 Gyroscope Built-in ELRS Receiver
Here is our set up which use with current FW on the Unit and Futaba 14SG, You can try if you want : HERE
Includes:
– RotorFlight F722V2 Gyroscope Built-in ELRS Receiver x 1 set
Configuration:
Main control: STM32F722RET6
Gyroscope: BMI270
Black Box: W25N01G (128MB)
Barometer: SPL06
Color light: WS2812
Buzzer: 5V active buzzer
USB：Type-C
Serial ports: UART2, UART3, UART5
I2C：I2C1
ADC：ADC1（12S）
Servo Channel: CH1-CH4
RPM input: RPM_E (ESC RPM line), RPM_S (RPM sensor)
Built-in receiver: ELRS dual antenna receiver 2.4G (serial port 1)
External receivers: CRSF, S.BUS, F.PORT, GHOST, SUMD, SUMH, IBUS, XBUS, XBUS/RJ01, EXBUS, PPM, MSP, DSM (with its own BEC step-down 3.3V power module)
BEC voltage: 5-15V
5V power output: 5V-1.5A
ESC protocols: PWM, ONESHOT125, ONESHOT42, MULTISHOT, BRUSHED, DSHOT150, DSHOT300, DSHOT600, PROSHOT
Disclaimer:
Rotorflight is open-sourced software, no warranty or implied as to the quality and reliability of this firmware, it is supported by the users themselves as a community.Rotorflight is under GPLv3 license. If handled incorrectly, RC models can cause serious injury or even death, and you are solely responsible for your model if you decide to use Rotorflight firmware. Any injury or damage caused by the use of Rotorflight firmware is not the responsibility of the authors of Rotorflight, the designers of RF gyroscopes, or the distributors, so please use with caution.
