Description
Axisflying 5″ Brushless Top Quality FPV Motor AF236-1960KV For Arco / Flow / Bando Freestyle
*Forword
– AF series motor are axisflying highest quality line with Premium performance, the highest standard.
– The motors have a ton of top end power while still being tame enough on the bottom end to fly low and fast. When I tested them, I rarely used the top 25 percent of the throttle but it was nice to know it was there for when I wanted to do huge punch outs or if I needed to get out of a bad situation. Even though the motors were quite coggy when spinning them slowly in my hands, they were very smooth while flying. I paired the motors with the new, low pitch Gemfan F3 props to keep the motors in the relative power range that I am used to. I usually fly 1700kv motors and 5143 pitch props. The spot that I flew at had a river in the middle so I did my best not to crash. The one crash I did have was in fine dirt. The motors were originally crunchy after the crash but once the sand worked it’s way out, the o ring that protects the bearing did it’s job. Although I cannot comment on durability yet, I really enjoyed the way the motors flew and they have a beautiful design. In the future, I will use a throttle cap when flying them in tight bandos – From USA Pilots: Rotor Bob
*Bearing Shield Technology
– An IP53 rating dustproof and waterproof bearing placement design.
– BST protects from environmental elements and prolongs the smoothness and lifespan of the bearng .
– Increased thrust effciency and say goodbye to crush motor bearings
*Specs
– 1810KV is for flow style freestyle @6S
– 1960KV is for arco style freestyle @6S
– 2410KV is for lightweight freestyle @4S
– Configuration: 12N14P / N52H arc magnet
– Motor stator size: 2306
– Motor mounting hole size: 4*M3 (Φ16mm)
– Motor cables: AWG 20#, 150MM
– Motor dimensions (Dia *Len): Φ28.3*30.6MM / M5 shaft
– Motor weight (excluding 150MM cables) : 28.9g
– The motor is very powerful that can get over 1.6KG and most current is about 38A
*Package
– 1* AF236 motor
– 4* M3*8 screws for motor
– 1* M3*4 screw for lock shaft
– 1* M5 Flanged Nylon Insert lock
– 1* O-ring
– 2* Washers
